Daewoo Nexia

Since 1994 of release

Repair and car operation


Дэу the Nexia
+ The maintenance instruction
+ Maintenance service
- The engine
   2.1. Technical characteristics
   2.2. Greasing system
   2.3. Maintenance service and engine repair
   2.4. Compression check
   2.5. Dismantle and engine installation in gathering
   2.6. Engine support
   2.7. An inlet collector and a lining
   2.8. A final collector and a lining
   2.9. A cover of the case of a cam-shaft
   2.10. A pulley of a cranked shaft
   2.11. A forward cover of a gear belt
   2.12. A camshaft cogwheel
   2.13. A cogwheel of a cranked shaft
   2.14. A back cover of a gear belt
   2.15. Adjustment of a tension of a gear belt
   2.16. Check of angular position of a camshaft
   2.17. Forward consolidation of a cranked shaft
   2.18. A camshaft. Levers. Hydrojacks of backlashes
   2.19. Klapannye springs. Consolidations of cores of valves
   2.20. A head of cylinders. The camshaft case
   2.21. Repair of a head of the block of cylinders
   2.22. Dismantle of valves
   2.23. Directing plugs of valves
   2.24. Expansion of apertures of plugs
   2.25. Valves
   2.26. Klapannye springs
   2.27. Saddles of valves
   2.28. Consolidations of valves
   2.29. Height of a core of the valve concerning a head of the block of cylinders
   + 2.30. Pushers of valves with hydrojacks of backlashes
   2.31. The oil pallet
   2.32. A reception branch pipe with the oil filter
   2.33. The oil pump
   2.34. Repair of the oil pump
   2.35. Pistons and rods
   2.36. A flywheel. Back consolidation of a cranked shaft
   2.37. A cranked shaft
   2.38. Rods and radical bearings
   2.39. Replacement of loose leaves
   2.40. Piston group and rods
   2.41. Piston fingers and rings
   2.42. The block of cylinders
   2.43. Installation of pistons
   2.44. Balancing of a disk with a gear wreath
   2.45. Repair of carving apertures
   + 2.46. Diagnostics of malfunctions of the engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment






2.5. Dismantle and engine installation in gathering To remove or disconnect

PERFORMANCE ORDER
1. The relay of the fuel pump.
2. To start the Engine and to allow to it to work to a stop.
3. To scroll a cranked shaft within 10 seconds.
4. A negative wire of the storage battery and "a mass" wire of the engine.
5. To merge cooling liquid (to remove the bottom hose of a radiator).
6. An air cleaner branch pipe.
7. The top hose of a radiator.
8. A heater hose.
9. A cable from the case throttle заслонки.
10. Vacuum hoses:
      – The brake amplifier;
      – The vacuum gauge;
      – From the inlet pipeline to испарительному to a tank;
      – From the case throttle заслонки to испарительному to a tank.
11. A cable from the case throttle заслонки to transmission (only an automatic transmission).
12. Fuel pipelines from the case throttle заслонки.
13. Sockets of electric wires:
      – The ignition distributor;
      – A plait of wires of the control panel;
      – The gauge of concentration of oxygen;
      – The gauge of pressure of oil;
      – The gauge of temperature of a cooling liquid;
      – The speedometer gauge;
      – Fuel atomizers of system of injection of fuel;
      – The gauge of position throttle заслонки;
      – The idling valve;
      – "Mass" wires of the case of a cam-shaft and an inlet collector;
      – To remove electroconducting collars.
14. The coil of ignition with wires.
15. A mnogoshtyrevoj socket of electroconducting of the control panel.
16. A socket of the switch of a lantern of a backing.
17. A socket of the valve of blocking of the hydrotransformer (only an automatic transmission).
18. The neutral/start switch.
19. To lift the car.
20. The final pipeline with neutralizer.
21. A stopper from картера transmissions and to take out приводной the platen.
22. A cable of the condenser for suppression of hindrances from картера transmissions.
23. A coupling guard.
24. The bottom bolts of fastening картера couplings to the block of cylinders.
25. To lower the car.
26. To attach cables to engine loops.
27. To substitute support under transmission.
28. A forward right support of the engine.
29. A forward left support of the engine.
30. A back support of the engine.
31. The top bolts of fastening картера couplings to the block of cylinders.
32. To disconnect the Engine from картера couplings and to lift the Engine.

To establish or attach

PERFORMANCE ORDER
1. To lower the Engine and to connect with картером couplings.
2. The top bolts of fastening картера couplings to the block of cylinders.
3. A forward right support of the engine.
4. A forward left support of the engine.
5. A back support of the engine.
6. To clean support from under transmission.
7. To unhook cables from loops.
8. To lift the car.
9. A coupling guard.
10. The bottom bolts of fastening картера couplings to the block of cylinders.
11. The privodnoj platen of coupling.
12. A cable of the condenser for suppression of hindrances to картеру transmissions.
13. The final pipeline with neutralizer.
14. The bottom hose of a radiator.
15. To lower the car.
16. The neutral/start switch.
17. A socket of the valve of blocking of the hydrotransformer (only an automatic transmission).
18. A socket of the switch of a lantern of a backing.
19. A mnogoshtyrevoj socket of electroconducting of the control panel.
20. The coil of ignition with wires.
21. Sockets of electric wires:
      – The ignition distributor;
      – A plait of wires of the control panel;
      – The gauge of concentration of oxygen;
      – The gauge of pressure of oil;
      – The gauge of temperature of a cooling liquid;
      – The speedometer gauge;
      – Fuel atomizers of system of injection of fuel;
      – The gauge of position throttle заслонки;
      – The idling valve;
      – "Mass" wires of the case of a cam-shaft and an inlet collector.
22. To establish electroconducting collars.
23. Fuel pipelines to the case throttle заслонки.
24. A cable from the case throttle заслонки to transmission (only an automatic transmission).
25. Vacuum hoses:
      – The brake amplifier;
      – The vacuum gauge;
      – From the inlet pipeline to испарительному to a tank;
      – From the case throttle заслонки to испарительному to a tank.
26. A heater hose.
27. The top hose of a radiator.
28. An air cleaner branch pipe.
29. To fill in cooling liquid.
30. A negative wire of the storage battery and "a mass" wire of the engine.