Daewoo Nexia

Since 1994 of release

Repair and car operation

18.7.1. Partial replacement of a glutinous fringing

THE GENERAL DATA

Rotary finger and windscreen emphasis

1. THE WINDSCREEN EMPHASIS 2. THE ROTARY FINGER

To remove or disconnect

Dismantle of a rotary finger

1. THE PLATEN OF THE LEVER OF THE SCREEN WIPER 2. THE WINDSCREEN 3. THE ROTARY FINGER 4. THE WINDSCREEN EMPHASIS

Windscreen dismantle

1. THE STRING

PERFORMANCE ORDER

1. Levers of a screen wiper and an external ventilating lattice. 1а. To remove plastic caps from platens of levers of a screen wiper. 1б. To turn away a nut and to remove levers of a screen wiper with шлицевых shafts of platens. 1в. To turn out three screws and to remove a ventilating lattice. 2. The bottom rotary fingers and a windscreen emphasis (on one from each party of the car). 3. An internal rear-view mirror. 4. A sealant and a cord from a forward rack. 5. Right and left decorative молдинги a windscreen. By means of a knife for sealant removal to make an incision the parties and sealant top as it is possible more close to a glass edge. To insert outside a string between glass and the Body and by means of the second mechanic to cut off a glutinous layer on the bottom edge of glass. 6. A windscreen from the car. 7. The bottom decorative strip of a windscreen.

To clear

PERFORMANCE ORDER

1. An aperture of a window from the rests of all materials. 2. Glass on perimetre of an edge for the subsequent drawing of preparatory layers. 3. To wipe a windscreen the pure fabric moistened in spirit.

To establish or attach

Drawing on a windscreen of priming structure

1. THE NEW BRUSH 2. STRUCTURE FOR PRIMING COAT DRAWING

Drawing герметизирующего structure

Thickness of the platen of glutinous structure – 5 mm.

Windscreen installation

1. BACK GLASS 2. THE EMPHASIS OF BACK GLASS

PERFORMANCE ORDER

1. The bottom emphasis of a windscreen the flat party turned upwards. To establish a rotary finger. 2. By means of a new brush to put on edge has flown down preparatory layers, using corresponding structures from a repair set. At first it is necessary to put a priming coat from transparent structure, and then from structure of black colour. Priming coats put on perimetre of an edge of glass. Priming put on edge perimetre has flown down a strip the in width of 6 mm. 3. Top, lateral and bottom молдинги on a windscreen edge. 4. On perimetre of an edge of a window aperture to put уретановый glutinous structure in the form of the platen in the thickness of 5 mm (fig. Drawing герметизирующего structure). 5. By means of the second mechanic to establish a windscreen on the car. Сцентриро вать glass in the Body aperture. Use of rubber suckers can facilitate windscreen installation (fig. windscreen Installation). 6. To turn a windscreen emphasis clockwise so that flat parts of an emphasis have appeared in the bottom position. 7. To check up tightness of consolidation of a windscreen, watering. At detection негерметичности it is necessary to dry glass and in addition to impose герметизирующий structure. If it was not possible to eliminate a leak, it is necessary to remove glass and to repeat all installation anew. 8. Levers of screen wipers and an external ventilating lattice. 8а. To establish into place a ventilating lattice and to fix its three screws. 8б. To establish levers of screen wipers on шлицевые platens. 8в. To screw nuts of fastening of levers. 9. An internal rear-view mirror. 10. A sealant and a cord on a forward pile. 11. Right and left decorative молдинги a windscreen.