Daewoo Nexia

Since 1994 of release

Repair and car operation



Дэу the Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
- Brake system
   17.2. The general description
   17.3. Check of a technical condition of brake system
   17.4. Filling of a tank of the main brake cylinder
   17.5. Removal of air from brake system
   17.6. Washing of brake system
   17.7. Check of a regulator of brake forces
   17.8. Brake hoses (lobbies)
   17.9. Brake hoses (back)
   - 17.10. A lay brake
      17.10.1. The lever of a lay brake
      17.10.2. A cable of a lay brake
      17.10.3. The handle of the lever of a manual brake
   17.11. Check of a condition of forward brake overlays
   17.12. Check of a condition of back brake overlays
   17.13. Brake disks
   17.14. Brake drums
   17.15. A brake pedal
   17.16. The main brake cylinder
   17.17. A tank
   17.18. Regulators of brake forces (proportional valves)
   17.19. The main brake cylinder in gathering
   17.20. Repair of the main brake cylinder
   17.21. The disk brake mechanism
   17.22. Колодки and overlays
   17.23. A protective cover of the piston
   17.24. A brake disk
   17.25. A support
   17.26. A guard
   17.27. Support repair
   17.28. The drum-type brake mechanism
   17.29. Adjustment of the brake mechanism
   17.30. Adjustment of a lay brake
   17.31. A basic brake disk
   17.32. The wheel cylinder
   17.33. Repair of the wheel cylinder
   17.34. The vacuum amplifier of brakes
   + 17.35. Antiblocking system of brakes
   17.36. Removal of air from a brake hydraulic drive
   17.37. Removal of air from a brake hydraulic drive manually
   17.38. The valve for removal of air from the block of modulators
   17.39. Electromagnetic valves of modulators
   17.40. The block of hydraulic modulators with electric motors
   17.41. The electronic block of management of braking
   17.42. The gauge of angular speed of a forward wheel
   17.43. Flexible conducting ДУС of a forward wheel
   17.44. The gauge of angular speed of a back wheel
   + 17.45. Flexible conducting ДУС of a back wheel
   17.46. A system electric safety lock
   17.47. Relay ABS
   17.48. Signalling devices
+ Body
+ Heating, ventilation
+ Electric equipment






17.10.2. A cable of a lay brake To remove or disconnect

PERFORMANCE ORDER
1. To lower the lever of a lay brake.
2. To raise it is a little car to remove back wheels.
3. Brake drums. If necessary it is necessary to take away back разжимной the lever of a lay brake, having inserted a screw-driver into an aperture of a basic disk of a brake.
4. To lift the car.
5. Nuts of fastening of a heat-shielding casing to put a casing on the muffler.
6. A cable 106 from the equalizer 103. Before демонтажем the equalizer to measure length of a free carving of adjusting draught of a lay brake (to an adjusting nut).
7. A cable 106 from directing on трансмиссионном the tunnel.
8. Plastic directing from кронштей on on a fuel tank.
9. A cable from directing on a beam of a back suspension bracket.
10. To take out holders of a cable from plastic plugs on basic brake disks.
11. Tips of a cable from разжимного the lever of a lay brake and to take out a cable from basic brake disks.

To establish or attach

PERFORMANCE ORDER
1. A new cable to разжимным to levers of a lay brake, having inserted cable tips into apertures of basic brake disks.
2. To insert plastic plugs into basic brake disks and запрессовать in them holders of a cable.
3. Brake drums and lock screws. If at dismantle of a brake drum разжимной the lever has been shifted back, it is necessary to establish it in a starting position and to adjust a lay brake.
4. A cable 106 in directing on a beam of a back suspension bracket. To insert the plastic plug into an arm of a fuel tank.
5. A cable in directing on трансмиссионном the tunnel, having convinced that I direct щая black colour it is located from above.
6. The equalizer 103, a collar and a cable on adjusting draught and to screw a new nut in position which was occupied with an old nut before dismantling.
7. A heat-shielding casing.
8. If at dismantle of a brake drum разжимной the lever has been shifted back, it is necessary to adjust a lay brake (subsection 17.28 see).
9. Wheels. To tighten bolts of fastening of wheels the moment of 90 Nanometers.
10. To lower the car.