Marks of proportional valves
To remove or disconnect
The prevention As valves отрегули рованы in pairs, they are subject to replacement only in the complete set.
To replace a cover of 1 tank with the level gauge with a usual carving cover that the signalling device on a control panel did not join.
| PERFORMANCE ORDER |
| 1. Pipelines from proportional valves 10. |
| 2. To turn out valves 10 of the case 5 main cylinders. |
|
To establish or attach
The prevention Before installation of valves 10 it is necessary to be convinced that they have identical marks of cases, fig. Marks of proportional valves.
| PERFORMANCE ORDER |
| 1. To screw valves 10в the case 5. To tighten valves 10 moment of 20-25 Nanometers. |
| 2. Pipelines to valves 10. To tighten unions of pipelines the moment of 12-18 Nanometers. (At check of 16 Nanometers). |
| 3. To remove air from a hydrodrive. |
| 4. To check up tightness of a hydrodrive. |
| 5. To check up level of a brake liquid. |
| 6. To remove a technological cover and to establish on a tank a cover with the level gauge. |
|
|