Daewoo Nexia

Since 1994 of release

Repair and car operation

Дэу the Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
- Brake system
   17.2. The general description
   17.3. Check of a technical condition of brake system
   17.4. Filling of a tank of the main brake cylinder
   17.5. Removal of air from brake system
   17.6. Washing of brake system
   17.7. Check of a regulator of brake forces
   17.8. Brake hoses (lobbies)
   17.9. Brake hoses (back)
   + 17.10. A lay brake
   17.11. Check of a condition of forward brake overlays
   17.12. Check of a condition of back brake overlays
   17.13. Brake disks
   17.14. Brake drums
   17.15. A brake pedal
   17.16. The main brake cylinder
   17.17. A tank
   17.18. Regulators of brake forces (proportional valves)
   17.19. The main brake cylinder in gathering
   17.20. Repair of the main brake cylinder
   17.21. The disk brake mechanism
   17.22. Колодки and overlays
   17.23. A protective cover of the piston
   17.24. A brake disk
   17.25. A support
   17.26. A guard
   17.27. Support repair
   17.28. The drum-type brake mechanism
   17.29. Adjustment of the brake mechanism
   17.30. Adjustment of a lay brake
   17.31. A basic brake disk
   17.32. The wheel cylinder
   17.33. Repair of the wheel cylinder
   17.34. The vacuum amplifier of brakes
   + 17.35. Antiblocking system of brakes
   17.36. Removal of air from a brake hydraulic drive
   17.37. Removal of air from a brake hydraulic drive manually
   17.38. The valve for removal of air from the block of modulators
   17.39. Electromagnetic valves of modulators
   17.40. The block of hydraulic modulators with electric motors
   17.41. The electronic block of management of braking
   17.42. The gauge of angular speed of a forward wheel
   17.43. Flexible conducting ДУС of a forward wheel
   17.44. The gauge of angular speed of a back wheel
   + 17.45. Flexible conducting ДУС of a back wheel
   17.46. A system electric safety lock
   17.47. Relay ABS
   17.48. Signalling devices
+ Body
+ Heating, ventilation
+ Electric equipment

17.36. Removal of air from a brake hydraulic drive

The necessary equipment:

– Device SCANNER-11.
The prevention

Before removal of air from system it is necessary to result pistons of modulators of forward and back wheels in extreme top position. For this purpose it is necessary to give a command by means of device SCANNER-11 (button F5). Operation of reduction of pistons of modulators in a starting position cannot be carried out, if ТЭБУ codes of malfunctions are established. In the presence of flowing КН it is necessary to eliminate at first all defects and to clear memory ТЭБУ from КН, and then to result pistons in a starting position.

1. To lift and fix properly car redock, to hang out forward driving wheels.
2. To start the Engine, to include transfer to transmissions and to deduce the Engine on frequency of rotation of the shaft, corresponding to speed of movement of the car more than 5 km/h. To allow to work to the engine in such mode not less than 10 with.
3. To check a signalling device condition "ABS". The signalling device should be switched off after approximately 3 with. If the signalling device "ABS" continues to burn more than 3 with, it is necessary to carry out diagnostics of malfunctions by means of device SCANNER-11. If the signalling device "ABS" dies away and remains switched off, to switch off the Engine and to repeat operations 2 and 3 once again.
4. By means of device SCANNER-11 included in a mode of manual testing to give a command to modulators on затормаживание all wheels.
5. To execute operations on removal of air from a brake hydrodrive.
The prevention

It is authorised to use a brake liquid which was stored only in the pure and densely closed container. It is forbidden to apply a brake liquid from open capacities as the liquid гигроскопична and can contain a significant amount of dissolved steams of water. It is not necessary to use a brake liquid of mark DOT 5 (кремнийорганическую).