Daewoo Nexia

Since 1994 of release

Repair and car operation



Дэу the Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
- 7. Ignition system
   7.2. Diagnostics of malfunctions of a spark plug
   7.3. The ignition distributor
   7.4. The ignition coil
   7.5. Repair of the distributor of ignition
   7.6. System of regulation of an advancing of ignition
   7.7. Installation of the moment of ignition
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment






7.2. Diagnostics of malfunctions of a spark plug
THE GENERAL DATA

The worn out or polluted candles can well idle the engine, but at increase in frequency of rotation of a shaft of the engine their work is broken. The raised expense of fuel, loss of capacity by the engine, reduction of the maximum speed of the car, difficult start-up of the engine and other signs of abnormal work of the engine specify in unsatisfactory work of spark plugs. Spark plugs can fail because of a strong deposit, infringement of a normal amount of a backlash between electrodes or insulator destructions. Pollution of spark plugs because of intensive adjournment of a deposit occurs at long work of the engine on low turns and at frequent short trips when the Engine, as a rule, has not time to warm up ся to normal temperature. Deposit occurrence is promoted by the worn out piston rings, bad work of system of the ignition, too rich fuel mix and wrong selection of candles on калильно му to number (too "cold" candles for the given engine). The backlash increase between electrodes after small run of the car testifies to engine operation on the forced modes or wrong selection of candles on калильному to number (too "hot" candles for the given engine). Deterioration of an electrode can be also a consequence of an overheat of a candle because of leak of hot gases through thinnesses in a carving (the candle is insufficiently tightened). Too poor fuel mix also promotes deterioration of electrodes. Insulator destruction can be a consequence of wrong installation of a candle or casual handling at backlash adjustment between electrodes, and also falling or blow. The insulator crack can not be shown at once, it becomes appreciable after a while at hit in it to a dirt. Usually the insulator bursts under the case of a candle and to notice a crack it is impossible.