Daewoo Nexia

Since 1994 of release

Repair and car operation



Дэу the Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
- Electric chain
   6.2. The general description
   6.3. Rules of care of the accumulator
   6.4. Accumulator check
   6.5. Accumulator gymnastics
   6.6. The storage battery
   6.7. System of start-up of the engine
   6.8. Diagnostics of malfunctions
   6.9. Algorithm of diagnostics of malfunctions
   6.10. The traction relay
   6.11. Муфта a free wheeling (МСХ)
   6.12. Repair of knots of a starter 5МТ and 10МТ
   6.13. The generator
   6.14. Diagnostics of malfunctions of generator CS-121
   6.15. Generator dismantle
   6.16. Generator CS-130 repair
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment






6.4. Accumulator check
THE GENERAL DATA

The degree indicator заряженности and level of electrolit of unattended accumulator DELCO

 


Decoding of the symbols put on a label of the accumulator

1 – At accumulator service it is necessary to observe rules under the safety precautions, stated in the operation manual.
2 – In the accumulator there is a corroding acid and it is necessary to be careful, that acid has not spilt from the accumulator.
3 – do not use open fire about the accumulator.
4 – At work with the accumulator use goggles.
5 – Hold the accumulator in a place not accessible to children.
6 – At recycling the accumulator hand over only in the points intended for it.
7 – do not throw out the accumulator together with household dust.
8 – Gaza, allocated at accumulator gymnastics are explosive.

In the accumulator it is necessary to make check of density of electrolit each 3 months to define loading ability of the accumulator.

Check is made плотномером. At definition of density of electrolit it is necessary to consider accumulator temperature. At electrolit temperature more low 15 With on everyone 10 less than this temperature from the measured density subtract value 0,007. For everyone 10 from above 15 add 0,007.

The electrolit density in the accumulator should be in following limits:

Temperature
Above 25 With
More low 25 With
Full gymnastics
1,210 – 1,230
1,270 – 1,290
Gymnastics on 70 %
1,170 – 1,190
1,230 – 1,250
The discharged
1,050 – 1,070
1,110 – 1,130

Electrolit density measure in everyone bank. The difference in density 0,04 or more between two any banks specifies in loss of electrolit or сульфатацию plates.

If the electrolit density between two any banks differs more than on 0,04 accumulator is subject to replacement. If below demanded, but identical in all banks, the accumulator it is necessary to charge density of electrolit.

In case of use of the unattended accumulator the accumulator condition can be checked up only the voltmeter. In accumulators with the built in indicator of degree заряженности the accumulator condition is defined on colour of the indicator. Green colour of the indicator corresponds to full gymnastics of the accumulator. Black colour of the indicator specifies in necessity of gymnastics of the accumulator. Light or bright yellow colour of the indicator testifies to low level of electrolit in the accumulator (fig. the degree Indicator заряженности and level of electrolit of unattended accumulator DELCO see).

On the accumulator there is a label with warning symbols (fig. Decoding of the symbols put on a label of the accumulator) see.