Daewoo Nexia

Since 1994 of release

Repair and car operation


Дэу the Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
- 10. A five-speed transmission and the main transfer RPO MM5
   10.2. The general description
   10.3. Diagnostics of malfunctions
   10.4. The possible reasons of the raised noise of a transmission
   10.5. Level check трансмиссионного oils
   10.6. Adjustment of a drive of the mechanism of switching
   10.7. The gear change lever
   10.8. The floor mechanism of management of a transmission
   10.9. Draught of the mechanism of management
   10.10. The intermediate lever
   10.11. A speedometer drive
   10.12. A cover of the mechanism of the switch
   10.13. Consolidations of semiaxes
   10.14. Transmissions in gathering
   10.15. Dismantling of a transmission and the main transfer
   10.16. Characteristic malfunctions of a transmission and the possible reasons
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment






10.10. The intermediate lever
THE GENERAL DATA

Drive of the mechanism of switching

210. THE BOLT
211. THE WASHER
212. КЛЕММОВЫИ THE CLIP
213. THE ADJUSTING TIP WITH THE EYE
214. DRAUGHT
220. THE PLUG
223. THE AXIS CLAMP
224. THE PLATEN WITH THE PLUG
237. THE HINGE AXIS
238. THE INTERMEDIATE PLATEN WITH THE LEVER
239. THE LEVER AXIS
241. THE PLATEN

The kardannyj hinge of a drive of the mechanism of management

223. THE AXIS CLAMP
237. THE HINGE AXIS

The hinge of the intermediate lever

217. THE INTERMEDIATE LEVER
220. THE PLUG
239. THE LEVER AXIS

To remove or disconnect

PERFORMANCE ORDER
1. A negative wire of the battery.
2. Draught 214.
3. A clamp of 223 axes and an axis 237 карданного the hinge.
4. To disconnect a bolt клеммового соедине ния.
4а. To disconnect a tip 213 from the platen 214.
5. An axis 239 intermediate levers and a spring clamp 221.
6. The intermediate lever 217, a tip 213 and the platen 238 with the lever.
7. Plugs 219 and 220.
8. Spring rings of hinges of the intermediate lever and to disconnect a tip 213 and the lever of the platen 238.

To establish or attach

Installation of plugs of an axis of the intermediate lever

217. THE INTERMEDIATE LEVER
220. THE PLUG

PERFORMANCE ORDER
1. A tip 213 and the lever of the platen 238 to the intermediate lever 217.
1а. To establish spring rings of hinges.
2. To insert plugs 220 into the lever 217. Before installation to grease plugs with silicone greasing.
3. The intermediate lever on an axis 239. To check up reliability of installation of a spring clamp.
4. A tip 213 on the platen 241.
5. An axis 237 карданного the hinge and a spring clamp of 223 axes. Before installation to grease an axis with silicone greasing.
6. Draught 214.
7. To adjust a drive and to tighten a bolt 210 клеммового connections.
8. A negative wire of the battery.