At service of a pedal of an accelerator it is necessary to observe following requirements. Interfaced planes of an arm of a suspension bracket of a pedal and forward board of the Body should be free from изоляционного a material. The rug, a floor and tunnel covering should be straightened and not have folds.
To pass a cable in a cut of draught of an accelerator and to establish a clamp, having checked up correctness of its position. Cautiously запрессо вать a clamp in a draught aperture not to overwind a cable or not to damage it in another way. After assemblage to check up freedom of movement and absence of jammings of a drive throttle заслонки and accelerator pedals in a full range of movings. Wires, hoses and other details should not be more close 13 mm to mobile details of a drive throttle заслонки at any position of a pedal of an accelerator. |