Daewoo Nexia

Since 1994 of release

Repair and car operation

Дэу the Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
- 16. A back suspension bracket
   16.2. The general description
   16.3. Maintenance service and repair
   16.4. Check of size of forces of a friction in a suspension bracket
   16.5. Bearings of wheels
   16.6. The shock-absorber
   16.7. The stabilizer
   16.8. Springs
   16.9. Plugs of hinges of a back suspension bracket
   16.10. A back suspension bracket in gathering
   16.11. A nave
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment

16.11. A nave To remove or disconnect

Consolidation dismantle

AND. THE SCREW-DRIVER

10. CONSOLIDATION
12. THE NAVE

PERFORMANCE ORDER

1. To lift the car and to fix properly.

2. Wheels.

3. Brake drums (the lock screw, if necessary to weaken a cable of a lay brake to take away inside by means of a screw-driver разжимной the lever of a lay brake).
The prevention
It is forbidden to knock a hammer on a brake drum as it can put out of action bearings.

4. A protective cap 17, шплинт 15 and a nut 16.

5. A nave 12 with a lock washer 14.

6. Consolidation 10 from a nave 12 by means of a screw-driver.

7. A separator with rollers and an internal ring of the conic bearing 11 from a nave 12.

8. An external ring of the bearing 11 from a nave 12 by means of a stripper or approaching a small beard.

9. An external ring of the bearing 13 from a nave 12 by means of a stripper or approaching a small beard.

10. To clear a pin and to check up its technical condition, presence of defects.

To establish or attach

Installation of consolidation of the internal bearing

12. THE NAVE

PERFORMANCE ORDER

1. Запрессовать against the stop an external ring of the bearing 13 in a nave 12 by means of assembly adaptation KM-266A.

2. Запрессовать against the stop an external ring of the bearing 11 in a nave 12 by means of assembly adaptation KM-266A.

3. The internal bearing 11.

4. To grease or fill консистентной with greasing for bearings all cavities of bearings 11 and 13, an edge of consolidation 10 and a nave 12.

5. Запрессовать consolidation in a nave 12.

6. A nave 12 and a lock washer 14 on a pin.

7. A nut.

8. A brake drum.

8а. To tighten the lock screw of a brake drum.

8б. To establish back wheels and to tighten bolts the moment of 90 Nanometers.

9. To adjust bearings of wheels.

10. To adjust a lay brake.

11. To lower the car.