Daewoo Nexia

Since 1994 of release

Repair and car operation

14.8. The spherical hinge

THE GENERAL DATA

Spring clamp

AND. THE BACK HANDLE CENTURY FORWARD LOOPS WITH. CLAMPS 1. THE SPRING CLAMP

To remove or disconnect

Removal of rivets of the spherical hinge

PERFORMANCE ORDER

1. To release bolts of fastening of forward wheels. 2. To lift the car. 3. To bring basic racks under the car or under suspension bracket support. 4. To lower it is a little car so that he leant against racks, but not on the bottom levers. 5. Forward wheels. The prevention To track that полуось did not leave the internal mobile hinge. It will lead to hinge dismantling. Probably also hinge damage. During work in a zone of an arrangement of hinges of semiaxes it is necessary to use the protective covers which are put on on rubber грязезащитные of consolidation of hinges. Otherwise damage of details or consolidations of hinges and an exit of hinges out of operation is possible. 6. A spring clamp of 1 nut of the spherical hinge 6. 6а. To raise the back handle of a clamp and to take out it for forward loops, fig. the Spring clamp see. 7. The spherical hinge 6 from a rack 33. To use a stripper for spherical hinges KM-507V. 8. The bottom lever. 9. To drill heads of three rivets of fastening of the spherical hinge and to beat out rivets from apertures бородком. For drill вания to use 12-mm a drill.

To establish or attach

Boltovoe fastening of the spherical hinge to the lever

PERFORMANCE ORDER

1. The spherical hinge 6 on the bottom lever 13. 2. Three bolts with nuts in apertures of rivets in the bottom lever (instead of rivets). To tighten nuts the demanded moment. Nuts should be established from below the lever. 3. The bottom lever.