To remove or disconnect
Dismantle of steering draught
(ONLY FOR CARS WITH AUTOMATIC TRANSMISSION)
AND. POSITION OF CUTS ON THE FIXING PLATE AT INSTALLATION
CENTURY THE WRENCH
WITH. FOR SIMPLIFICATION OF INSTALLATION TO APPLY A THIN FILM КОНСИСТЕНТНОЙ GREASINGS ON THE PLUG
(ONLY FOR CARS WITH THE MANUAL TRANSMISSION)
23. STEERING DRAUGHT (LEFT)
21. THE FIXING PLATE
25. THE BOLT
26. THE BASIC PLATE (ONLY FOR CARS WITH THE MANUAL TRANSMISSION)
27. THE PLUG OF THE HINGE OF STEERING DRAUGHT
30. THE WASHER
32. CARTER'S CASING
33. ДЕМПФЕР THE STEERING (ONLY FOR CARS WITH AUTOMATIC TRANSMISSION)
PERFORMANCE ORDER
1. Fixing plate 24.
2. A coupling bolt 22.
3. A bolt of 25 fastenings of the internal hinge of steering draught. The prevention
At simultaneous dismantle of both steering draughts it is necessary after removal of the first draught, to screw into place a bolt 25 to keep mutual position рейки, a casing and a directing lath.
4. To deduce a head of steering draught from under a basic plate and to remove draught.
To establish or attach
PERFORMANCE ORDER
1. To check up, that washers 30 have been inserted into a casing 32.
2. Steering draught.
3. To screw a bolt 25. Bolts of fastening of steering bent for рейке рулевoгo the mechanism the moment of 90 Nanometers.
4. To screw a coupling bolt 22. To tighten a bolt клеммового connections of steering draught by the moment of 22 Nanometers.